What do I do to convert my TO-30 to a single wire alternator? If you convert the tractor to 12 volt you must wire it as 12 volt negative...

I am helping a friend with a MF65 where the clutch will not disengage. I pulled the inspection plate and a 3” pin fell out. Closer...

What are the downsides of clipping the axle shims when installing an axle? I am not sure there is a down side to cutting shims other...

Is there a recommended method to clean the sludge from the block, and crankcase of my ’49 TO 20?  September 13, 2016. The procedure...

Can I remove the sediment bowl on my TO-20 to clean the filter as long as the fuel tap is off?  September 18, 2016. Yes, that’s the way...

I read the article of yours in the Ferguson Furrows magazine. I have a 1958 TO-35 and the rear tires are full of calcium chloride. They...

When I did a first fit of the cowl section today, I noted that the choke rod would be bound tight if I would push the bracket through...

One of my stabilizer bars has a safety chain I have never seen before. It’s the same light duty chain that the linch pins are clipped to...